Vaddio WideSHOT WallVIEW SR - Manual (Page 9)

WideSHOT WallVIEW SR
WideSHOT WallVIEW SR System Document Number 342-0695 Rev B Page 9 of 20
Step By Step Installation Instructions:
Step 1: After determining the optimum location of the camera, route, mark and test the
two Cat-5 cables from the camera to the Quick-Connect SR Interface located at the
head-end. The two Cat-5 cables should feed-through the hole located on the rear flange
of the supplied Thin Profile Wall Mount. The bracket can be mounted to a 1-gang wall
box. If the mount is to be mounted on a 1-gang wall box, use the screws supplied with
the wall box cover plate to attach the Thin Profile Wall Mount. If mounting to the drywall
with wall anchors, use two quality wall anchors (provided). Level the mount and tighten
the mounting screws.
Step 2:
Using the HD VIDEO SELECT rotary switch and CAMERA SETTINGS dip switches on the back of the camera,
set up the camera’s output resolution and functional preferences. There are tables on previous pages that
identify the choices…
maybe keep these tables handy for future use…or you can easily look them up on the
Vaddio website (vaddio.com) when needed.
Switches to set on the camera:
 Set the desired HD Resolution with the rotary selection switch.
 Set the IR frequency of the camera (if it is to respond to the IR remote control).
 Set the image orientation (normal or flipped).
On the WideSHOT camera, the remote will basically navigate through the OSD menus since the camera’s zoom,
iris and focus are manual.
Step: 3: Follow the sample wiring diagram for connecting the Cat-5 cables to the WideSHOT and Quick-Connect
SR Interface (yep, on the next page, but read and understand the rest of these instructions especially the next
note).
NOTE: Check all Cat-5e cables for continuity in advance of the final connection. Label the Cat-
5e cables. Plugging the EZ POWER HD VIDEO cable into the wrong RJ-45 may cause damage
to the camera system and void the warranty. For premise cabling, please use real RJ-45
connectors and crimpers. Please don’t use the pull through or EZ type of RJ-45 connectors.
Step 4: Place the camera onto the camera mount and use the provided ¼”-20 screws to secure the camera to
the mount. To dress the cabling, push the extra cable back into the wall opening.
Step 5: Connect the Vaddio 24 VDC, 2.0 Amp power supply to a power outlet and to the Quick Connect SR
Interface. Power will travel down the Power/Video Cat. 5 cable to the camera. The camera will boot up and in a
few seconds, HSDS (differential) video will travel back down the Cat-5 cable and be ready to accept control
information from the IR remote control or other camera controller.
To insure proper continuity of control and operation of the cameras, the RS-232 controller (control
system or joystick) should be powered on after the camera.