Hawk Industries Hawkjaw Sr. Manual M100K-2GSR Serial Numbers 201 to 370 - Manual (Page 24)

1. Follow the steps on pages 17-21.
2. Turn the Selector Switch (SS) to
Make.
3. Use the Red needle adjust (RNA)
to rotate the Torque gauge red
needle (RN) to the desired torque.
4. Rotate the Torque Set knob (K)
counter- clockwise as far as the
Torque Set knob (K) will turn.
5. Press in the Grip Hold (GH) button.
6. Press and hold Spin (S) until the
stand rotates down to the shoulder.
7. Release Spin (S). Immediately press
and hold Grip (G).
8. While holding down Grip (G), press
and hold Torque (T). While holding
down both Grip (G) and Torque (T),
rotate the Torque Set knob (K)
clockwise.
9. When the Torque gauge needle
(TN) reaches the desired torque,
stop rotating the Torque Set knob
(K).
10. Release both Torque (T) and Grip
(G) at the same time.
11. Pull out the Grip Hold (GH) button.
Setting Make Up Torque Setting Make Up Torque
SS G GH
T S K
RN RNA TN
22 Operation
Shown set for 35,000 ft. lbs.