Hawk Industries Hawkjaw Sr. Manual M100K-2GSR Serial Numbers 201 to 370 - Manual (Page 29)

1. Center the Suspension Ring (SR)
on the Lateral tilt screw (LTS).
2. Push and hold down Winch On
(WOn) to move the HawkJaw onto
the drill pipe connection.
3. Use Raise (R) and Lower (L) to
center the Middle wrench dies (MD)
and the Bottom wrench dies (BD)
between the shoulder (S).
4. Keep the Bottom wrench dies (BD)
away from the Hard banding (HB).
5. Keep the Middle wrench dies (MD)
and Bottom wrench dies (BD) away
from the shoulder (S).
Continued on next page...
Position for Break Out Position for Break Out
BD HB
S
WOn
SR LTS
L
R
MD
Operation 27