Hawk Industries Hawkjaw Sr. Manual M100K-2GSR Serial Numbers 201 to 370 - Manual (Page 63)

6. Place the new Grip Cylinder
into the Cap side Eye (CE) and
Rod side Eye (RE).
7. Use the Two 1 1/2" wrenches to
replace the Grip Cylinder Cap
side Bolt (CB).
8. Replace the Grip Cylinder Rod
side Bolt (RB). Assemble with
cotter pin.
9. Use the Two 11/16" wrenches to
connect the Cap side Hose
(CH).
10. Use the Two 11/16" wrenches to
connect the Rod side Hose
(RH).
11. Make sure no bodily parts are
in the retract path of the Torque
Cylinder. Turn on the
hydraulic power unit. Pull out
the “E” stop. The Middle
wrench will retract.
Part Numbers
Part Name Part #
Grip Cylinder Cap Bolt (CB) 999-806627
Lock Washers 061-91074A038
Grip Cylinder Rod Bolt (RB) 061-20270
Cotter Pin 061-98401A446
Grip Cylinder (C) 061-H18S
Maintenance & Repair 61
Changing the Grip Cylinder
WARNING
Make sure the Grip Cylinder Rod
and Cap side Hoses are properly
connected. See Drawings.
Grip Cylinder Seals
CE RH CH
RE RB C CB
Grip Cylinder Seals
E
Changing the Grip Cylinder