NaceCare Solutions TTV5565 - Manual (Page 16)

16
Breakaway floor-tool
Fig.26
The floor-tool design incorporates a breakaway feature.
Allowing it to safely disengage from its mounting should it
become caught on an obstruction, during forward machine movement.
(See Fig.26)
Fig.27
To re-attach the blade to its holder.
First loosen the retaining knobs on the floor-tool body and slide onto the
holding bracket.
Tighten retaining knobs to finger tight.
(See Fig.27)
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
NOTE: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles.
! !
To operate, turn the master control On / Off key to the ‘On’
position, select water flow rate, chemical mix (see page 14).
lower the floor-tool (see page 13) and select forward (see page 8,
Fig.4), press the start / stop trigger.
Vacuum pick-up, water-flow and chemical-dose will turn on
automatically and the machine will move forward.
Adjust the speed to suit the conditions using the variable speed
control (see page 8).
The clean water / chemical mix is dispersed evenly via
‘THRU- FEED’ scrubbing brushes.
The waste water is then retrieved by the suction floor-tool
(see page 9).
Overlap each scrubbing path by 10cm to ensure
an even clean.
Do not operate the machine on inclines that exceed (9%), when
full.
If streaking occurs wipe floor-tool blades clean (see Fig.29).
On heavily soiled floors use a ‘double scrub’ technique.
First pre-scrub the floor with the floor-tool in the raised position,
allow the chemical time to work then scrub the area a second
time with the floor-tool lowered.
Fig.28
Fig.29
Machine Operation
Machine in use