NaceCare Solutions TTV5565 - Manual (Page 18)

18
Next remove floor-tool vacuum hose and flush out with clean water.
Next empty clean-water tank, using emptying hoseand again flush out with clean
water.
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY
MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY.
REMOVE THE KEY PRIOR TO ANY MAINTENANCE OPERATION.
! !
After use, empty waste-water tank using emptying
hose and flush-out with clean water.
A
A
B
C
B
C
Whilst pressing in the top tank hood toggles,
remove the hood (Fig.31)
The hood also has a sealing-rubber which
should be examined at
every clean-down.
Rinse using clean water, avoiding the vac filter
(Fig.31a).
IMPORTANT:
Remove white vac filter and clean if required (keep dry) (Fig.31a).
Never use the machine without the recommended filter as it may cause damage to
the machine (Fig.31a).
Remove debris basket filter and rinse using clean water, and refit.
IMPORTANT:
If the debris basket is allowed to become clogged, vacuum performance can deteriorate.
(Fig.31b)
The clean-water tank filter is located to the rear of the battery compartment,
and should be checked at regular intervals.
Unscrew the cap check the filter condition (Fig.31c), rinse and refit.
Ensure tank has been emptied and care is taken when working in the vicinity of
batteries.
Fig.31
Fig.31a
Fig.31b
NOTE:
ANY SPILLS SHOULD BE WIPED-UP BEFORE THE TOP TANK IS
LOWERED.
Located in your waste water (top) tank is a full tank switch, this stops your
machine from working once the waste water reaches its maximum limit.
Sometimes the switch gets clogged and blocked, clean to ensure correct
operation (see page 15).
Fig.31 c
Regular Maintenance