Pathway Pathport Manager 3 User Guide - Manual (Page 16)

Pathport Manager User’s Guide
16
8. Make sure that your PC's IP address is correctly noted in the "Local IP"
box. If it is not, enter it and press enter. The Pathport will use the Local
IP parameter to find out where to request firmware from.
9. Enter an IP range that does not include your PC's IP address. For
example, if your PC's IP address is 10.0.0.5, you should enter 10.0.0.101
into the Address Range Start box, and 10.255.255.254 into the Address
Range end box.
10. If your network contains multiple subnets connected by a router, you can
also specify a subnet mask and a default gateway to facilitate routing.
11. Once you have configured these parameters, click "Exit".
12. Connect your Pathport network and power up your nodes. They should all
boot normally and show up (after a few seconds) in Pathport Manager's
network tree view. The nodes will appear as green icons with green text
denoting that they have not already been added to the show.