Pathway Pathport Manager 3 User Guide - Manual (Page 22)

Pathport Manager User’s Guide
22
To connect an output to a source simply drag an output port to a universe and
drop it on top of a universe.
The last step is to clear the existing patch information from the nodes. The
Pathports are shipped patched to the default configuration, which allows for out-
of-the-box performance without the need for Pathport Manager. This patch HTP
merges all A inputs and connects them to all A outputs, and all B inputs to all B
outputs. This is done via the "Quick Patch" system.
If this configuration is not desired click the "Clear Patch" button on the toolbar.
This will unassign the default patch and make the system ready for new patches.
When the patch is cleared, all output ports will be moved to the "Available
Outputs" window. To disconnect a single output, you can also drag it from the
universe it is assigned to (within the Patch Frame) and drop it onto the "Available
Outputs" window.
The system is now ready for operation.