Meteor ProMover 1200 CYM - Manual (Page 2)

It is, however, recommended to protect the supply lines of the projectors from indirect contact and/or
shorting to death by using appropriately sized residual current devices.
Hooking up to the supply mains
Connection to the electricity mains must be carries out by a qualified electrical installer.
Check that the mains frequency and voltage correspond to those for which the projector is designed
as given on the electrical data label.
This label also gives the input power to which you need to refer to evaluate the maximum number of
fittings to connect to the electricity line, in order to avoid overloading.
Pay attention to size the neutral conductor of three-phase systems adequately if the version is used
with an electronic power supply unit without p.f. correction since the neutral current is equal to the
sum of the currents on all the active phases.
The last warning does not hold for versions equipped with an electronic power supply unit with PFC
or with an electromagnetic power supply unit.
Temperature of the external surface
The maximum temperature that can be reached on the external surface of the fitting, in a thermally
steady state, is 160 degrees C (320 degrees F).
Maintenance
Before starting any maintenance work or cleaning the projector, cut off power from the mains
supply. After switching off, do not remove any parts of the fitting for at least 10 minutes. After this
time the likelihood of the lamp exploding is virtually nil.
If it is necessary to replace the lamp, wait for another 15 minutes to avoid getting burnt.
The fitting is designed to hold in any splinters produced by a lamp exploding. The lenses must be
mounted and, if visibly damaged, the have to be replaced with genuine spares.
Lamp
The fitting mounts a high-pressure lamp that needs an external igniter. This igniter is fitted onto the
apparatus.
-Carefully read the “operating instructions” provided by the lamp manufacturer.
-Immediately replace the lamp if damaged or deformed by heat.
Unpacking and Preparation
Unpacking
Cut the straps, open the top of the cardboard box and take out all the accessories. Then take off
the supporting sides and lift the outer strip. Open the plastic bag and take the projector off the
bench: position it on an easily accessible flat surface where you can carry out the following
preliminary operations.
Packing contents
The pack contains the illustrated accessories as well as the projector.
Fitting eyebolts
Extract a screw from each side of the base and replace them with the two eyebolts supplied, reusing
the flat and elastic washers.