Meteor ProMover 1200 CYM - Manual (Page 4)

Switching on the projector
Press the switch checking it all works properly. At switch on, the software contained in the DMX
Receiver microprocessor does a checksum (automatic check) while the three-figure display is off
and the three LED’s controlling the input signal are all on. After a few seconds, the projector starts
the mechanical zero setting of the effects. Only at the end of this procedure it switches on (option 3
OFF), or you can switch on (option 3 ON) the lamp.
After the information has scrolled, the projector address will stay displayed. You can also scroll the
aforesaid information by turning all the rotary selector switches of the addresses to zero or by
setting the TEST microswitch to ON. Alternatively you can set the projector to blackout (with all the
channels on zero).
Setting the projector start address
For each STAGE ZOOM, the starting address must be set for the digital signal. To do this, you
need to operate three rotary selector switches for unit (1), tens (10) and hundreds (100), bearing in
mind that each STAGE ZOOM occupies 16,17, 19 or 20 control channels. The start address setting
operation can also be done with the projector switched off.
MAINTENANCE
Locking and releasing Pan and Tilt movements
-Refer to the instructions in the UNPACKING AND PREPARATION section.
Opening and closing the side covers
-Refer to the instructions in the UNPACKING AND PREPARATION section.
Lamp change
-Refer to the instructions for lamp change and regulation in the UNPACKING AND PREPARATION
section.
Zero setting the working hours and number of times the lamp is switched on
To zero the hours of the lamp’s life (“Bulb hours”) and the number of times it is switched on (“Bulb
strikes”) which are stored in the DMX Receiver microprocessor, proceed as follows:
1. Set the TEST microswitch to the ON position.
2. Shift the DISPLAY microswitch from ON to OFF (or from OFF to ON) and vice versa 3 times
within a time of 6 seconds. If the procedure has been carries out correctly, the three-signal
control LED’s will light up simultaneously, while the display will go completely blank. This
situation lasts for approximately 5 seconds.
3. Return the TEST microswitch to the OFF position.
Extracting effects kit
Open the effects compartment, disconnect the connector gripping it by its side lugs and forcing in
the direction shown by the arrow, taking care not to stretch the wires, then release, turning the four
levers of the quick lock/release devices anti-clockwise. Slowly lift the effects kit till it comes
completely out of the projector head, taking care over any interference with the wiring cables of the
movable head. Rest this effects kit on a flat surface in the position shown.
IMPORTANT: when handling the effects kit, it must be gripped by the framework and not the
motors, wiring, effects wheels or other parts that could easily get damaged or deformed.
Inserting effects kit
Position the bundle of wires for wiring the effects kit motors outside the movable head, as shown in
the figure. Prepare the PROMOVER 1200 CYM effects kit by manually turning both gobos discs to
turn the empty positions (without gobos) towards the outside of the kit. Lift the effects kit above the