Nilfisk-ALTO RS 850 - Manual (Page 144)

ENGLISH USER MANUAL
30 33014576(4)2008-02 A RS 850
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed when the machine is off (ignition key removed).
Moreover, read carefully the instructions in Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual contains the Scheduled Maintenance Table and describes only the easiest and most common maintenance
procedures.
For other maintenance procedures contained in the Scheduled Maintenance Table or for extraordinary maintenance procedures see
the Service Manual that can be consulted at any Service Center.
For scheduled and extraordinary maintenance of the following optional equipments, refer to the relevant Manuals:
Salt spreader
Snow brush
Camera kit
SCHEDULED MAINTENANCE TABLE
Maintenance
Running-in pe-
riod (after the
fi rst 50 hours)
Every 10
hours or
before use
Every
150
hours
Every
300
hours
Every
500
hours
Every
1,000
hours
Every
2,000
hours
Engine oil level check
Hydraulic system oil level check
Engine air pre-fi lter and fi lter cleaning
Engine radiator fi n cleaning check
Engine coolant level check
Hydraulic system oil cooler fi n check
Battery fl uid level check
Hopper, fi lters and suction hose cleaning. Fan bearing
lubrication. Hopper gasket check.
Water nozzle and fi lter cleaning
Brake fl uid level check
Reverse gear buzzer operation check and sensor
adjustment
Diesel engine start-up safety system check (8)
Tyre pressure check
Suction inlet and skirt height and operation check
Side broom position check and adjustment
3rd broom position check and adjustment
Hopper and suction hose gasket wear check (8)
Dust control system water fi lter cleaning
Alternator belt tension check (8) (8)
Climate control system compressor belt tension check (8) (8)
Parking brake check
–
–
–