Nilfisk-ALTO RS 850 - Manual (Page 154)

ENGLISH USER MANUAL
40 33014576(4)2008-02 A RS 850
Rear wheel removal/installation
Place a jack (6, Fig AQ) under the relevant housing (9) in the rear axle (7), as shown in the fi gure.
Loosen tyre nuts before jacking.
WARNING!
The jack (6, Fig. AQ) is not part of the machine equipment. Use a suitable jack with a minimum lifting capacity of
4,410 lb (2,000 kg).
Activate the jack (6, Fig. AQ) carefully, and lift the wheel (8) until it is slightly detached from the ground.
Unscrew the mounting nuts and remove the wheel (8, Fig. AQ).
Install the wheel (8, Fig. AQ) by performing steps from 11 to 13 in the reverse order.
Wheel mounting nut tightening torque: 295 lb·ft (400 N·m).
FUSE REPLACEMENT
Engage the parking brake (13, Fig. E).
Turn the ignition key (24, Fig. D) to OFF position and remove it.
Remove the transparent cover of the fuse box (25 or 34, Fig. D) and replace the relevant fuse among the following:
Fuse box (25, Fig. D)
Free fuse holder (10 A)
Free fuse holder (7.5 A)
Parking brake warning buzzer and water-in-fuel sensor fuse (10 A)
Dashboard fuse (7.5 A)
Reverse gear warning buzzer, cameras, start safety relay, and hopper lid fuse (10 A)
Skirt solenoid valve fuse (10 A)
Broom rotation fuse (10 A)
Relay board fuse (10 A)
Lifted hopper warning light/windscreen washer fuse (7.5 A)
Dust control system water pump fuse (15 A)
Climate control system fuse (15 A)
Hydraulic system oil cooling fan fuse (20 A)
Fuse box (34, Fig. D)
High beam fuse (15 A)
Running light fuse (7.5 A)
Hazard warning light and horn fuse (10 A)
Low beam fuse (15 A)
Running light fuse (7.5 A)
Glow plug control unit fuse (7.5 A)
Turn signal fuse (7.5 A)
Flashing light fuse (7.5 A)
Fuel solenoid valve fuse (engine off) (10 A)
Brake light fuse (10 A)
Windscreen wiper fuse (7.5 A)
Climate control system blower fuse (20 A)
Install the transparent cover of the fuse box (25 or 34, Fig. D).
12.
13.
14.
15.
16.
1.
2.
3.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
4.