Rugged Ridge XHD Low Mount Snorkel Kit, 07-11 Jeep Wrangler (JK) - Manual (Page 17)

Page 17 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
95
- Place windshield cowl
cover back onto vehicle.
94
- Inspect “Z”-bracket to
snorkel alignment.
Adjust snorkel body
and “Z”-bracket to
align mounting holes.
96
- Align driver’s side top
holes and insert (2)
M6 x20 Phillips head
screws and washers.
Secure but do not tighten.
97
- Check alignment of
cowl cover and snorkel
body. Insert M6 x 20
Phillips head screws
to align cover, snorkel
and “Z” bracket. Make
sure snorkel body is
located firmly against
inner frame. Remove
cowl screws and cowl
cover.
98
- With cowl cover removed
tighten “Z”- bracket .
Reinstall cowl cover and
reinstall drivers side
M6 x 20 screws and
washers. Reattach center
retainer clips removed
in step (5).
99
- Locate cowl nut plate.
Nut plate is used to
secure cowl cover and
snorkel body to “Z”
bracket.