Rugged Ridge XHD Low Mount Snorkel Kit, 07-11 Jeep Wrangler (JK) - Manual (Page 7)

Page 7 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
34
- Test fit fender gasket as
shown. Gasket should
rest flat onto fender. If
gasket does not fit flat
around cut opening trim
inner antenna bracket as
needed.
35
- With gasket in place test
fit main body of snorkle
into cut section as shown.
Trim fender as needed.
Avoid getting to close to
the outer edge of fender.
Trimming too far will result
in a visible gap (arrow) .
36
- Use 100 grit sand paper or
sanding block to smooth
rough cut metal.
37
- With opening trimmed
to correct size and edges
smoothed apply a
protective coat of paint.
Matching touch up paint
is recommended. Clear
coat can also be used.
38
- Apply a very small amount
of super glue to inner
corners of fender gasket.
It will be easier to start at
on end and work around
opening. Applying glue
as needed. This will insure
gasket remains in place
during reasembly.
39
- Trim extra gasket as
needed.