Rugged Ridge XHD Low Mount Snorkel Kit, 07-11 Jeep Wrangler (JK) - Manual (Page 8)

Page 8 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
44
- Locate 10mm bolt securing
fuel sending unit wire loom
to left hand side of frame
(passenger side). Bolt is
located just under exhaust
manifold heat shield.
Loosen bolt but do not
remove.
45
- Insert aluminum air tube
from fire wall forward
between shock tower and
engine. Front of tube
will fit under power steering
hard line and to the left
of power steering pump.
42
- Disconnect factory air
intake tube from upper
air box, place to the side.
Upper air box will be
reused. Do Not Discard.
40
- Using a flat head screw
driver loosen 3” hose
clamps at intake and
air box. Pull hose away
from air box and rotate
out of the way.
43
- Remove lower air box
from vehicle. Air box is
held in place with location
pins. Simply pull upwards
and out of rubber retainer
grommets.
NOTICE: Clamps from
lower air box will be reused.
41
- Unlatch upper air box
from lower air box.
Remove factory air filter
and set to the side. Filter
can be reused if clean. A
high flow aftermarket
air filter is recommended
for use with snorkel.