Rugged Ridge XHD Low Mount Snorkel Kit, 07-11 Jeep Wrangler (JK) - Manual (Page 18)

Page 18 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
101
- Secure all (4) M6 cowl
mounting screws. Make
sure M6 black washers
are placed under M6
screws before tightening.
100
- Slide nut plate under
snorkel body as shown.
Working from engine
compartment align
mounting holes. Start
one M6 Phillips head
screw to hold in place.
102
- Reinstall wiper arms
removed in step (4).
103
- Slide 3/8” drain hose
and 3/8” clamp to
bottom of snorkel
body.
104
- Hose should be cut
into two lengths. Top
section should be
about 8” long. The
lower section will be
4” and trimmed as
needed. Connect 3/8”
clamps to valve and
tighten all (3) clamps.
105
- Drain should be
checked before fender
is installed. Open and
close valve.
Drain should be
lowered and checked
to remove any excess
water on a regular basis.