Rugged Ridge XHD Low Mount Snorkel Kit, 07-11 Jeep Wrangler (JK) - Manual (Page 3)

Page 3 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
10
- Remove 5 inner fender
bolts (arrows). Note
location of bolts. Bolts
will be reused.
11
- Following four images show
locations of key inner fender
bolts. Rear inner bolt may be
recessed under inner fender
liner. See arrow for bolt
location.
12
- Remove top fender
support bolt.
13
- Remove front inner bolt.
Bolt is located under inner
liner just behind front grill.
14
- Loosen inner door fender
bolts. Do not remove. Allow
enough clearance for
fender to slide out easily.
Notice: If door remains
installed bolts should be
removed to avoid damage
to vehicle if door is closed.
15
- Remove lower pinch weld
fender bolts. Note location
of bolts. Bolts will be reused
NOTICE: On some models
rock rails or side steps will
need to be removed before
bolts can be accessed.