APC IN ROW RD ACRD101 - Manual (Page 33)

25 InRow RD 10 kW Air Cooled Operation and Maintenance
Network Configuration
The cooling unit is shipped with a Network Management Card that enables the cooling unit to be
managed over a network. Configure the network settings for the Network Management Card for this
cooling unit from the display interface. The management card allows remote control and configuration
of the equipment.
Configure network
Path: Main > ConfigureNetwork
MAC Address. Displays the unique network identifier which was assigned to the Network
Management Card of this cooling unit at the factory.
Boot Mode. Set the method by which the Network Management Card of the cooling unit acquires
network settings.
• Manual: Enter the IP address, subnet mask, and default gateway using the IP Address menu.
• BOOTP: Set the Network Management Card of the cooling unit to obtain its network settings
from a BOOTP server.
• DHCP: Set the Network Management Card of the cooling unit to obtain its network settings from
a DHCP server.
By default, DHCP requires an APC cookie before it will accept an IP address. See
“BOOTP & DHCP configuration” on page 33 for more information.
• BOOTPDHCP: Set the Network Management Card of the cooling unit to search for its network
settings from either a BOOTP or a DHCP server.
IP Address. You will be prompted to enter an Admin password. Enter the password and press
ENTER
to
return to the IP screen. Press
ENTER
again to change the network settings for Manual boot mode only.
• IP: Enter the IP address assigned to the Network Management Card of this cooling unit.
• SM: Enter the subnet mask for the Network Management Card of this cooling unit.
• GW: Enter the default gateway for the Network Management Card of this cooling unit.