Kramer Electronics TP-410 - Manual (Page 13)

10 TP-410 - Connecting the TP-410
6. Connect the 10 TP OUTPUT STP/UTP connectors to up to 10 TP receivers
(for example, the TP-126 or additional TP-410 units).
7. If required, you can connect a PC and/or controller to the:
 RS-232 terminal block (see Section 5.2
 RS-485 terminal block (see
)
Section 5.3 and Section 6

Ethernet connector (see
)
Section 5.4
8. Set the DIP-switches (see
)
Section 7
9. Connect the power cord (not shown in
)
Figure 3 ).
We recommend that you use only the power cord that is supplied with this machine
Figure 3: Connecting the TP-410, UXGA-Audio-RS-232 Line Transmitter / DA
When using the TP as the source, adjust the EQ/LEVEL trimmers
immediately after turning the power ON. It is recommended to perform
this adjustment using the OUT local display.
i