Kramer Electronics TP-410 - Manual (Page 16)

TP-410 - Connecting the TP-410 13
13
Figure 5: Local Area Connection Properties Window
6. Select Use the following IP Address, and fill in the details as shown in
Figure 6 .
7. Click OK.
Figure 6: Internet Protocol (TCP/IP) Properties Window
5.4.2 Connecting the ETHERNET Port via a Network Hub (Straight-Through
Cable)
You can connect the Ethernet port of the TP-410 to the Ethernet port on a network
hub or network router, via a straight-through cable with RJ-45 connectors.
5.4.3 Ethernet Port Configuration
To configure the Ethernet parameters, set DIP-switches 1 to 4 to ON (ON-ON-ON-
ON), turn the power off and then back on.