Kramer Electronics VP-770 - Manual (Page 50)

VP-770 - The Display Modes 45
45
7.2.3.4 Selecting the PiP Source via the OSD Menu
You can select an input source only after you set the display mode
to one of the PiP configurations (see Section
7.2.1
).
To set the PiP source via the OSD menu, do the following:
1. Press the MENU button to access the OSD menu.
2. Scroll through the menu, and for window specific submenus check the menu
title:
 If PiP Window Control appears, continue to step 7
 If not, continue to the next step
3. Press the button to move to the Misc menu and press ENTER.
4. Select the OSD submenu and press ENTER.
5. Select Window Control and choose PiP Window Control.
The OSD menu controls the PIP source
6. Press the MENU button a number of times to return to the main OSD menu
(and accept changes).
7. Scroll to the Input menu and press ENTER.
8. Select Input Source and press ENTER.
9. Choose the input for the PiP window.
10. Press the MENU a few times until you exit the OSD menu (changes are
saved upon exit).
i