Kramer Electronics VP-770 - Manual (Page 55)

50 VP-770 - Controlling the VP-770
8.5.3 Ethernet Port Configuration and Control
Use the Kramer K-UPLOAD software to configure and control the VP-770 via the
Ethernet.
The latest version of K-UPLOAD and installation instructions can be
downloaded from the Kramer Web site at
http://www.kramerelectronics.com/support/product_downloads.asp
8.6 Controlling the VP-770 via the REMOTE Terminal Block
Connector
The REMOTE terminal block connectors include:

A PIP pin and a G pin which are used for toggling between the Single and
Dual window modes, and for selecting a PiP input

Nine input pins (defined in the table below) and a G pin for selecting an input
PIN# Input Source PIN# Input Source PIN# Input Source
1 HDMI 1 4 PC 2 7 CV 2
2 HDMI 2 5 COMP. 8 DP
3 PC 1 6 CV 1 9 N/A
The contact closure remote control pins operate in a similar way to the INPUT
buttons (see Section 8.1 ). Using the contact closure remote control (also known as
push-to-make momentary contact) you can select any of the inputs. To do so,
momentarily connect the required input pin (1 to 8) on the REMOTE terminal block
connector to the G (Ground) pin of the REMOTE terminal block connector, as
Figure 30 illustrates.
Do not connect more than one input PIN to the GND PIN at the same
time.
Figure 30: Connecting the Contact Closure Remote Control PINs
i
!