Sunlight Supply Samsung Programmable Thermostat for Split Systems - Manual (Page 6)

WWW.SUNLIGHTSUPPLY.COM
Distributed by:
(continued...)
sub-PCB INSTALLATION INSTRUCTIONS
2. Inside the unit, towards the bottom of the cabinet you will find a PCB wire
harness. Gently pull this wire upward and out of the unit.
3. Connect the PCB to the PCB wire harness (a) and to the sub-PCB wire
harness (b).
NOTE: the sub-PCB wire harness is included with the wired controller.
(a) (b)
4. Remove the protective tape (a) and slide all connected wires into the
groove beside the sub-PCB mounting location (b). Snap the sub-PCB cover
over the installed sub-PCB.
(a) (b) (c)