WIKA CS4S - Manual (Page 16)

Operating Instructions Temperature Indicating Controller CS4S
V1.1
•
10/2006 - 16 -
5.4 Auxiliary function setting mode 1
Character Name, Function, Setting range Default value
Setting value lock selection
• Locks the setting values to prevent setting errors.
The setting item to be locked depends on the designation.
• When Lock 1 or Lock 2 is designated, PID Auto-tuning and
Auto-reset cannot be carried out.
Unlock
• (Unlock) : All setting values can be changed.
(Lock 1) : None of the setting values can be changed.
(Lock 2) : Only main setting value can be changed.
(Lock 3) : All setting values can be changed. However, do not change the
setting items in the Auxiliary function setting mode 2. They return
to their former value after power is turned off because they are
not saved in the non-volatile memory. It is suitable to use in
combination with our programmable controller (with SVTC) as
this has no relation to memory life.
SV high limit setting
• Sets the set value high limit.
• Setting range: SV low limit to input range high limit value or SV
low limit to scaling high limit value
Input range
high limit value
SV low limit setting
• Sets the set value low limit.
• Setting range: Input range low limit value to SV high limit or
scaling low limit value to SV high limit
Input range
low limit value
Sensor correction setting
• Sets the correction value for the sensor.
• Setting range: –100.0 … 100.0 °C (°F) or –1000 … 1000 0.0 °C
Communication protocol selection
• Selects communication protocol.
• Available only when the option [CR5] is applied.
• WIKA protocol
：
Modbus ASCII mode ：
Modbus RTU mode ：
WIKA protocol
Instrument number setting
• Sets the instrument number individually to each instrument when
communicating by connecting plural instruments in serial
communication.
• Available only when option [CR5] is added.
• Setting range: 0 … 95
0
Data transfer rate selection
• Selects a transfer rate to be equal to the rate of the host computer.
• Available only when option [CR5] is added.
• 2400 bps:
, 4800 bps: , 9600 bps: , 19200 bps:
9600 bps
Parity selection
• Selects the parity.
• Not available when the option [CR5] is not added or when WIKA
protocol is selected in the Communication protocol selection.
• No parity: , Even parity: , Odd parity:
Even parity
Stop bit selection
• Selects the stop bit.
• Not available when option [CR5] is not added or when WIKA
protocol is selected in the Communication protocol selection.
• Setting range: 1, 2
1