Cirrus Logic CS2100-CP - Manual (Page 26)

CS2100-CP
26 DS840F2
8.2.3 PLL Clock Output Disable (ClkOutDis)
This bit controls the output driver for the CLK_OUT pin.
8.3 Device Configuration 1 (Address 03h)
8.3.1 R-Mod Selection (RModSel[2:0])
Selects the R-Mod value, which is used as a factor in determining the PLL’s Fractional N.
8.3.2 Auxiliary Output Source Selection (AuxOutSrc[1:0])
Selects the source of the AUX_OUT signal.
Note: When set to 11, AuxLckCfg sets the polarity and driver type. See “AUX PLL Lock Output Config-
uration (AuxLockCfg)” on page 28 .
ClkOutDis Output Driver State
0 CLK_OUT output driver enabled.
1 CLK_OUT output driver set to high-impedance.
Application: “PLL Clock Output” on page 20
7 6 5 4 3 2 1 0
RModSel2 RModSel1 RModSel0 Reserved Reserved AuxOutSrc1 AuxOutSrc0 EnDevCfg1
RModSel[2:0] R-Mod Selection
000 Left-shift R-value by 0 (x 1).
001 Left-shift R-value by 1 (x 2).
010 Left-shift R-value by 2 (x 4).
011 Left-shift R-value by 3 (x 8).
100 Right-shift R-value by 1 (÷ 2).
101 Right-shift R-value by 2 (÷ 4).
110 Right-shift R-value by 3 (÷ 8).
111 Right-shift R-value by 4 (÷ 16).
Application: “Ratio Modifier (R-Mod)” on page 18
AuxOutSrc[1:0] Auxiliary Output Source
00 RefClk.
01 CLK_IN.
10 CLK_OUT.
11 PLL Lock Status Indicator.
Application: “Auxiliary Output” on page 20