Cirrus Logic CDB48500-USB User Manual
Cirrus Logic Hardware
Advertising
Table of contents
Document Outline
- CDB48500-USB USB Evaluation Kit Guide
- 1 Introduction to the CRD48500-USB Evaluation Kit
- 2 Board Setup and Installing the Evaluation Kit Software
- 3 CDB48500 System Description
- 3.1 CDB48500 System Block Descriptions
- 4 Configuring the CDB48500
- Appendix A Schematics
- A.1 Introduction
- A.1.1 Schematic Pages
- A.1.1.1 Detailed Schematic Descriptions
- A.1.1.1.1 CS48500 System Block Diagram (See Figure 1-1)
- A.1.1.1.2 DSP Input Data Multiplexing (See Figure 1-2)
- A.1.1.1.3 Coyote DSP Core (See Figure 1-3)
- A.1.1.1.4 Serial Flash Memory (See Figure 1-4)
- A.1.1.1.5 S/PDIF Receiver (See Figure 1-5)
- A.1.1.1.6 Codec #1(CS42448) (See Figure 1-6)
- A.1.1.1.7 Codec #2 (CS42448) (See Figure 1-7)
- A.1.1.1.8 Codec 1 and Codec 2 Input Filters (See Figure 1-8)
- A.1.1.1.9 Output Filters & Headphone Output (See Figure 1-9)
- A.1.1.1.10 Mic and Pre-Amp (See Figure 1-10)
- A.1.1.1.11 Control Connector and Power (See Figure 1-11)
- A.1.1.1 Detailed Schematic Descriptions
- A.1.1 Schematic Pages
- A.1 Introduction
- Appendix B Troubleshooting Guide
- Revision History