FMI PDS100 - Manual (Page 7)

Page 7 of 18
Setup Screens (two individually controlled pumps) cont’d:
Control and start method
Input has the following available settings for Input control type and start method.
***Factory default values shown***
Control (Speed). Speed can be adjusted prior to run command from
one of the following 5 options listed below:
o RS485
o 4-20 mA
o 0-10 V. (VDC)
o 0-5 V. (VDC)
o Keypad. The pump speed can be adjusted via the keypad
up/down arrow keys.
Start. The pumps can be activated (started) from one of the following 5
options listed below:
o RS485
o Analog (pump(s) will start when a voltage is applied to the
pump(s) Analog Input(s) based on Table 2, pg. 12.
o Power Up: The pumps will start to dispense/meter after power is
applied. Note: The pumps initially “home” prior to starting the
dispense/metering process. In dispense mode the pumps will
stop rotating once the desired dispense count is reached. The
keypad stop button can also activate a stop command.
o Switch. Momentary closure will activate a pump in dispense
mode. In continuous mode the pumps will only rotate while the
switch is closed. Upon switch removal the pumps will complete
rotating until “home” is reached.
o Keypad. The pump will start when the keypad start key is
pressed and stop when the stop key is pressed.
To adjust either the control method or start method simply press the up or down
arrow keys to go to the desired item and then press the enter key.
To set the control method press the up/down arrow keys until the desired
control method is shown. Press the enter key to save. To set the start method
press the up/down arrow keys until the desired start method is shown. Press
the enter key to save. To exit setup press the setup key and the motor(s) will
automatically home or press the enter key to go to next setup screen.
Setup A = Inputs
‘ENTER’ FOR NEXT MENU
Control = Keypad
Start = Keypad
USE ARROWS TO SELECT
IN-PDS100-13A
11/1/13 HW