Norgren VP51 Datasheets - Manual (Page 2)

N/en 6.6.040.02 Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document.
VP51
2006-125d
8/13
Elbow connector M12 x 1
Page 4
0250081
Pin-No. Function
1 +24 V d.c. supply
2 0 ... 10 V feedback
3 Control signal (+VE)
4 Common (supply signal and feedback return)
5 Chassis
Setting Options
Language English, Español, Français, Italiano, Deutsch
Pressure units Bar, atm, kg/cm2, kPa, psi
Password Protection Protect against unauthorised adjustment of the valve
Off-line Set up Min Set up Set pressure between 0…10 Bar and Min – Max Signal
Max Set up Set pressure between 10…0 Bar and Min – Max Signal
Speed Setting Change the time taken to ramp between two pressures. (Volume dependent)
Dynamic Response Allows the Integrator settle time to be set
Dither Amp Amplitude of the dither on the spool
On-line Set up Min Set up Can be used for fine adjustment of output pressure at a given signal
Max Set up Can be used for fine adjustment of output pressure at a given signal
Monitor Set up Monitor Output Display feedback for user information.
Green Indicator Shows power is present and can be set to flash when the output pressure is outside specified limits
Red Indicator Normally off. Can be set to flash if the output pressure does not reach the required value within a specific time limit. Will also flash when the unit is set to local control.
Local Control Manual Control Valve output can be set using the arrow keys
Factory Defaults Option to resets the valve to the Factory default settings.
Single manifold
Page 4
ZZ5M00
Connecting plugs
Electrical connector pin looking
into the end of the instrument
Valve built in user adjustable settings
Characteristic curves
Manifold mount assembly to ISO 2 sub base
O-rings, flat seal and screws are included
1
2
5 3
4
10
9
8
7
6
5
4
3
2
1
0
0 200 400 600 800 1000 1200 1400 Nl/min
bar
10
4
2
0
6
8
200 0 400 600 800 1000 Nl/min
bar
Outlet pressure
Outlet pressure
Flow Flow
Forward flow characteristics
(supply pressure 11 bar)
Relief flow characteristics
(supply pressure 9 bar)