Norgren VP51 Datasheets - Manual (Page 4)

N/en 6.6.040.04 Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document.
VP51
2006-125d
8/13
Warning
These products are intended for use in industrial compressed
air and rail transport systems only. Do not use these products
where pressures and temperatures can exceed those listed under
‘Technical features’.
Before using these products with fluids other than those specified,
for non-industrial applications, life-support systems, or other
applications not within published specifications, consult NORGREN.
Through misuse, age, or malfunction, components used in
fluid power systems can fail in various modes.
The system designer is warned to consider the failure modes
of all component parts used in fluid power systems and to provide
adequate safeguards to prevent personal injury or damage to
equipment in the event of such failure.
System designers must provide a warning to end users in
the system instructional manual if protection against
a failure mode cannot be adequately provided.
System designers and end users are cautioned to review specific
warnings found in instruction sheets packed and shipped with
these products.
Manifold mount assembly to ISO 2 sub base
included all seals and screws
Connector
Connector, 90°
M12 x 1, 5 pin, female,
5 m cable length, A coded
Model: 0250081
34,5
13
44
11
11
95
2 1
1 Two screws M4 x 50 mm deep to mount the VP50 onto the manifold
2 Four screws M6x16 mm deep to mount the manifold onto the iso subbase
Ø 15
M12x1
27
39,5