Norgren 11-104 Series - Manual

See Section ALE-24 for Accessories
ALE-8-6 Littleton, CO USA Phone 303-794-2611 www.norgren.com
11-104
● Pilot regulators are used to control the outlet
pressure of a pilot operated regulator (ordered
separately)
● The pilot regulator is installed in an accessible
location in the compressed air system; pilot operated
regulator is installed at any point without regard to
accessibility
● Feedback pilot regulator provides superior pressure
regulation under changing flow demands where
changes in flow demand are not sudden or cyclic.
● Constant bleed feature provides maximum sensitivity
to system changes
● Relief feature allows reduction of downstream
pressure when the system is dead-ended
Feedback Pilot Regulator
1/4" Port Size
ISO Symbols
11-104 Feedback Pilot Regulator
with Pilot Operated Regulator
† Outlet pressures can be adjusted to pressures in excess or, and less than, those specified. Do not use these units to control pressures outside of
the specified ranges.
Ordering Information Model listed is relieving, constant bleed, 5 to 100 psig (0.3 to 7 bar) outlet pressure adjustment range†, with
PTF ports.
Port Size Type Model Weight lb (kg) Pressure psig (bar)
1/4" PTF Feedback Pilot 11-104-001 3.38 ( 1.53) 5-105 (.3-7)
1/4" PTF Feedback Pilot 11-104-002 3.38 ( 1.53) 50-250 (3-17)
Feedback Pilot Regulator Warning
The feedback line must sense the pilot operated regulator outlet pressure
and must be connected before turning on the air supply. If the feedback line
is not connected, the pilot operated regulator outlet pressure will rapidly
increase to the inlet pressure when the adjusting knob on the pilot regulator
is turned clockwise.