Norgren PUSH-IN Fittings - Manual

N/en 9.1.020.01 Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document. © 2014 Norgren Ltd
3/14
2006-9005e
Norgren Pneufit ® C fittings are ready to use,
offering fast assembly with no need for tools
providing optimum flow.
Pneufit
® C offers a broad range of over 1,000
composite push-in pneumatic fittings to complement
our established all brass Pneufit ® series.
Releasable stainless-steel grab-ring to grip
PA or PUR tube (85 or 95 durometer).
Nickel plated brass components provide corrosion
and contamination resistance and an extended life.
Pre applied thread sealant on all taper threads and
recessed captive O-ring on parallel threads provides
optimum rapid sealing.
Technical features
Medium:
Compressed air
Operating pressure:
10 bar max.
Vacuum:
750 mmHg
Tube sizes:
4, 6, 8, 10, 12 und 16 mm
Thread sizes:
M5, M6, 1/8, 1/4, 3/8 and 1/2
ISO G, ISO Rc and ISO R
Tubing types:
PA 11 or 12
PUR 85, 95 or 98 durometer
Operating temperature:
-20°C ... +60°C
Warning:
The Norgren Pneufit
® C range
must not be used in vehicle air
braking or ancillary systems. For
push in fittings suitable for these
applications, please refer to the
Fleetfit range.
Materials
Body: PBT
Seals: NBR (silicone free)
u-packing and O-rings
Threaded bodies: nickel plated
brass
Release sleeve and backing ring:
POM
Grab-ring: stainless steel
Collar: nickel plated brass
Thread sealant: chemitech G-
175L
1. Ensure that the end of the
tube is cut square and is free
from burrs. 2. Push the tube through
the collet into the fitting. 3. Continue pushing the tube
through the ‘O’-ring until it
bottoms on the tube stop then
pull back. 4. To disconnect push the tube
into the fitting, hold down the
collet and withdraw the tube.
Method of assembly
1 Impact resistant PBT body in black
2 Release buttons are red for metric, grey for inch
3 Stainless steel grab ring with special design to retain
softer tube and provide easy releasability.
4 Silicon free U-packing provides leak tight tube seal
under side loading.
5 Stem seal provides leak tight 360° swivel connection.
6 Nickel plated brass threads and notches on hex to
signify NPT.
7 Pre-applied thread sealant on tapered threads and
recessed captive O-ring on parallel threads.
1
2
4
7
3
5
6
C0 ˙˙˙˙˙˙˙
Thread size/tube size
Thread size/tube size
Option selector
Thread type
Shape
Pneufit ® C
PUSH-IN fittings, metric
Ø 4 ... 16 mm O/D tube