Installing the system into the rack – Acer Altos G510 series User Manual
Page 122
Advertising
Appendix B: Altos G510 Rack Installation Guide
112
Installing the system into the rack
To install the system into the rack:
1
Remove the front bezel from the server. Refer to page 40 for
detailed instructions.
2
Remove the top panel of the server.
(1) Remove the two rear screws that secure the top panel to the
chassis.
(2) Slide the top panel backward to detach it from the chassis.
3
Remove the stands from the server.
(1) Lay the server on its side on a flat, stable surface.
(2) Remove the single screw from the center of each of the
server’s four stands. Keep these for later use.
BB!H621!.!FO/cppl!!Qbhf!223!!Xfeoftebz-!Kbovbsz!9-!3114!!21;63!BN
Advertising