Lenovo H430 Desktop - Manual (Page 49)

Chapter 9. Replacing hardware
47
5. Slide the new optical drive into the bay from the back until it snaps into
position.
6. Screw the two screws back into place in the drive bay.
7. Connect the data and power cables to the drive.
8. Install the front bezel. Refer to “Removing and replacing the front bezel”.
9. Refer to the “Completing the installation”.
Replacing a PCIE adapter
Attention
Do not remove the computer cover or attempt any repairs before
reading the “Important safety information” in the Safety and Warranty
Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of the
Safety and Warranty Guide or HMM, go to the Support Web site at:
http://consumersupport.lenovo.com
The following procedure can be used for removing any PCIE adapters,
including Graphic Cards, TV-tuner Card and Wifi Cards.
To replace an adapter:
1. Remove the computer cover. Refer to “Removing the computer cover”.
2. Remove the screw that secures the latch to the chassis, open the
adapter latch , and remove the adapter by pulling it straight out of
the adapter connector.