Lenovo H430 Desktop - Manual (Page 60)

Hardware Maintenance Manual
58
Replacing the mouse
Attention
Do not remove the computer cover or attempt any repairs before
reading the “Important safety information” in the Safety and Warranty
Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of the
Safety and Warranty Guide or HMM, go to the Support Web site at:
http://consumersupport.lenovo.com
To replace the mouse:
1. Remove any media (disks, CDs, or memory cards) from the drives, shut
down the operating system, and turn off the computer and all attached
devices.
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse. Refer to “Locating connectors on
the front of the computer” and “Locating connectors on the rear of the
computer”.
Note
Your mouse may be connected to the standard mouse connector
at the rear of the computer or to a USB connector at either the
front or rear of the computer.
4. Disconnect the defective mouse cable from the computer.
5. Connect the new mouse cable to the connector.
6. Refer to the “Completing the installation.”