Lenovo THINKSERVER TD230 - Manual (Page 47)

7. Slide the new optical drive into the drive bay until it snaps into position.
Figure 23. Installing the optical drive
8. Connect one end of the signal cable 2 to the rear of the new optical drive and the other end to an
available SATA connector (SATA connector 5 recommended) on the system board. See “Locating
parts on the system board” on page 15. Then, locate an available five-wire power connector
1 and
connect it to the rear of the new optical drive.
Figure 24. Connecting the optical drive cables
Chapter 5 . Installing, removing, or replacing hardware 37