Lenovo THINKSERVER TD230 - Manual (Page 83)

• If you are removing the heat sink and fan assembly for microprocessor 1, disconnect the heat sink
and fan assembly cable from the system fan 2 connector on the system board. See “Locating
parts on the system board” on page 15. Then, remove the four screws
1 that secure the heat
sink and fan assembly.
Note: Carefully remove the four screws from the system board to avoid any possible damage. The
four screws are integrated parts of the heat sink and fan assembly and they cannot be removed
from the heat sink and fan assembly.
Figure 57. Screws that secure the heat sink and fan assembly for microprocessor 1
Chapter 5 . Installing, removing, or replacing hardware 73