Lenovo THINKSERVER TD230 User Manual
Page 68
This section provides instructions on how to remove the Ethernet card. Use any documentation that came
with the Ethernet card and follow those instructions in addition to the instructions in this section.
To remove the Ethernet card, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 23.
3. Lay the server on its side for easier operation.
4. The Ethernet card is a kind of PCI card. See “Removing a PCI card” on page 55 and follow those
instructions to remove the Ethernet card.
5. If you are instructed to return the removed Ethernet card to the manufacturer, follow all packaging
instructions and use any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to “Completing the parts replacement” on page 90.
Installing or removing the ThinkServer TD230 SATA RAID 5 Upgrade
This section provides instructions on how to install or remove the ThinkServer TD230 SATA RAID 5 Upgrade
(hereafter called the RAID 5 key). The RAID 5 key is an activation key, which you can install on the system
board to enable the RAID 5 configuration function of the onboard SATA RAID for your server.
Installing the RAID 5 key
Attention:
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that came with your product, and
“Guidelines” on page 21. To obtain a copy of the publications, go to:
This section provides instructions on how to install the RAID 5 key.
To install the RAID 5 key, do the following:
Attention: Electrostatic discharge (ESD) can damage the RAID 5 key. Always ground yourself and use a
ground strap before touching the option. Perform the following procedure at an ESD-safe workstation.
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 23.
3. Lay the server on its side for easier operation.
4. Touch the static-protective package that contains the RAID 5 key to any unpainted surface on the
outside of the server. Then, remove the RAID 5 key from the package.
58
ThinkServer TD230 Installation and User Guide