Lenovo ThinkServer TD200 - Manual (Page 70)

6. Install the fan cage assembly (see “Installing the fan cage assembly” on page
47).
Note: Make sure that all cables are routed so that they are not damaged
when inserting the fan cage assembly into the server.
7. Install the air baffle (see “Installing the air baffle” on page 132).
8. Rotate the power-supply cage assembly back into the server. Press the
power-supply cage release tab and rotate the power-supply cage assembly
into the chassis.
1 Power supply support bracket
2 Power-supply release tab
9. Install the side cover (see “Installing the side cover” on page 134).
10. Lock the side cover.
11. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing the rear adapter-retention bracket
To remove the rear adapter-retention bracket, do the following:
1. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
2. Unlock and remove the side cover (see “Removing the side cover” on page 43).
3. Remove all adapters and place the adapters on static-protective surface (see
“Removing an adapter” on page 95).
Note: You might find it helpful to note where each adapter is installed before
removing the adapters.
52 ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide