Lenovo ThinkServer TD200 - Manual (Page 91)

Removing a 3.5-inch hot-swap hard disk drive
Attention: To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each drive bay.
To remove a 3.5-inch hot-swap SAS or hot-swap SATA hard disk drive, do the
following:
1. Read the safety information (see “Safety” on page vii and “Installation
guidelines” on page 37).
2. Unlock the side cover.
3. Open the bezel. Place your finger on the pull-point area on the left side of the
bezel door and rotate it away from the server.
4. Rotate the drive tray handle of the drive assembly to the open position.
5. Grasp the handle of the drive and pull the drive out of the bay.
Chapter 5. Installing optional devices and replacing customer replaceable units 73