Lenovo ThinkServer TD200 - Manual (Page 85)

and set it aside.
8. Disconnect the tape drive cable from the system board.
9. Remove the screws that secure the tape drive 1 to the server.
10. Gently pull the drive out of the server.
11. If you are instructed to return the tape drive, follow all packaging instructions,
and use any packaging materials that are supplied to you for shipping.
Installing an optional tape drive
To install a optional full-high tape drive, do the following:
1. Remove the EMC shields from the drive bay, if installed.
2. Touch the static-protective package that contains the tape drive to any
unpainted metal surface on the server; then, remove the tape drive from the
package and place it on a static-protective surface.
3. Install the blue rails on the sides of the tape drive.
4. Align the rails on tape drive with the guides in the drive bay; then, slide the
tape drive into the server from the front of the server until it clicks into place.
Chapter 5. Installing optional devices and replacing customer replaceable units 67