Lenovo ThinkServer RD330 - Manual (Page 146)

8. Connect the signal cable 1 and the power cable 2 to the rear of the new optical drive.
Figure 83. Connecting cables to the rear of the optical drive
9. Slide the new optical drive with the retaining bracket and cables into the drive bay from the front until
it snaps into position.
Figure 84. Installing the optical drive for server models with 2.5-inch hard disk drives
10. Connect the other end of the signal cable to the SATA connector 0 on the system board and connect the
other end of the power cable to the backplane. See “Reinstalling the server cover and reconnecting
cables” on page 149.
11. If you are instructed to return the old optical drive, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 149.
Replacing the hot-swap hard disk drive backplane
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 69.
134 ThinkServer RD330 User Guide