Lenovo ThinkServer RD330 - Manual (Page 149)

8. Carefully lift up the backplane. When the hooks 1 on the chassis are aligned with the corresponding
holes in the backplane, slowly move the backplane a little bit outward. Then, completely remove the
backplane.
Figure 86. Removing the backplane
9. Touch the static-protective package that contains the new hot-swap hard disk drive backplane to any
unpainted surface on the outside of the server. Then, remove the new backplane from the package.
Note: Carefully handle the backplane by its edges.
Chapter 6 . Installing, removing, or replacing hardware 137