Lenovo ThinkServer RD230 - Manual (Page 48)

5. Press the riser card assembly (might having a PCI card installed) down into the appropriate PCI card slot
on the system board. Then, close the retention tab to secure the PCI card (installed on the riser card
assembly) and then install the fastening screw to secure the riser card assembly in place.
Note: The riser card assembly might have a PCI card already installed on it. Carefully fit the PCI card
into the server.
Figure 21. Installing the riser card assembly
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 67.
Removing the riser card assembly
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii and “Guidelines” on page 19.
This section provides instructions on how to remove the riser card assembly with a PCI card installed.
To remove the riser card assembly, do the following:
36 ThinkServer User Guide