Lenovo ThinkServer RD230 - Manual (Page 55)

Statement 2
DANGER
Danger of explosion if battery is incorrectly replaced.
When replacing the lithium coin cell battery, use only the same or an equivalent type that is
recommended by the manufacturer. The battery contains lithium and can explode if not properly
used, handled, or disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the system board battery, do the following:
Note: Follow any special handling and installation instructions that come with the replacement battery.
1. Hold the system board battery 1 and position one side of the battery into its socket. Then, press the
other side of the battery until it snaps into place.
Figure 27. Installing the system board battery
2. Make sure that the battery clip holds the battery securely.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 67. You need to use the
Setup Utility program and reset the configuration, such as the system date and time and passwords. See
“Starting the Setup Utility program” on page 72 for details.
Removing or installing the RAID controller
This section provides instructions on how to remove or install the RAID controller.
Removing the RAID controller
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii and “Guidelines” on page 19.
This section provides instructions on how to remove the RAID controller installed in your server.
Chapter 5 . Installing, removing, or replacing hardware 43