Lenovo ThinkServer RD230 - Manual (Page 50)

5. Remove the fastening screw that secures the riser card assembly 1 and lift the riser card assembly
straight up by its edges to remove it 2 .
Figure 23. Removing the riser card assembly (with a PCI card installed)
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to “Completing the parts replacement” on page 67.
Installing or removing a PCI card
This section provides instructions on how to install or remove a PCI card.
Installing a PCI card
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii and “Guidelines” on page 19.
This section provides instructions on how to install a PCI card.
To install a PCI card, do the following:
Note: Use any documentation that comes with the PCI card and follow those instructions in addition to
the instructions in this section.
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
38 ThinkServer User Guide