Lenovo ThinkServer RD230 - Manual (Page 54)

Removing the system board battery
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii and “Guidelines” on page 19.
This section provides instructions on how to remove the system board battery.
To remove the system board battery, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 21.
3. Locate the battery on the system board. See “Locating parts on the system board” on page 15.
4. Remove the system board battery.
Figure 26. Removing the system board battery
5. Dispose of the battery as required by local ordinances or regulations.
What to do next:
• To install a new system board battery, see “Installing the system board battery” on page 42.
• To work with another piece of hardware, go to the appropriate section.
Installing the system board battery
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii and “Guidelines” on page 19.
This section provides instructions on how to install the system board battery.
Be sure to consider the following information when you replace the battery in the server:
• You must replace the battery with a lithium battery of the same type from the same manufacturer.
• After you replace the system board battery, you must reconfigure the server and reset the system date
and time.
• To avoid possible danger, read and follow the following safety statement.
42 ThinkServer User Guide