Lenovo THINKSTATION D10 - Manual (Page 38)

4. Remove the failing hard disk drive from the bracket by flexing the bracket.
5. Install the new drive into the bracket, flex the bracket, and align the pins 1
through 4 on the bracket with the holes in the hard disk drive. See Figure 21.
Do not touch the circuit board 5 on the bottom of the hard disk drive.
6. Install the hard disk drive and bracket into the drive bay.
7. Connect the signal and power cables to the rear of the new hard disk drive.
8. Go to Chapter 4, “Completing the parts replacement,” on page 39.
Figure 20. Removing the hard disk drive
Figure 21. Removing the hard disk drive from the bracket
30 ThinkStation Hardware Installation and Replacement Guide