Replacing the optical drive, Replacing, Optical – Lenovo THINKSTATION D10 User Manual

Page 39: Drive, Removing, Diskette, Optional, Card, Reader

Advertising
background image

Replacing

the

optical

drive

Attention

Do

not

open

your

computer

or

attempt

any

repair

before

reading

the

“Important

safety

information”

in

the

Safety

and

Warranty

Guide

that

was

included

with

your

computer.

To

obtain

a

copy

of

the

Safety

and

Warranty

Guide,

go

to

the

Support

Web

site

at

http://www.lenovo.com/support.

This

section

provides

instructions

on

how

to

replace

the

optical

drive.

1.

Open

the

computer

cover.

See

“Opening

the

cover”

on

page

12.

2.

Remove

the

front

bezel.

See

“Removing

the

front

bezel”

on

page

14.

3.

Locate

the

optical-drive

connectors.

See

“Identifying

parts

on

the

system

board”

on

page

9.

4.

Note

the

location

of

the

optical-drive

cables.

Disconnect

the

signal

and

power

cables

from

the

rear

of

the

optical

drive.

5.

Press

the

drive

latch

1

(for

the

drive

you

want

to

remove)

and

slide

the

optical-drive

from

the

chassis.

See

Figure

22.

6.

Install

the

new

optical-drive

from

the

front

of

the

drive-bay

assembly.

Slide

the

optical-drive

toward

the

rear

of

the

chassis

to

lock

the

drive

into

position.

7.

Connect

the

flat

cable

to

the

new

optical-drive.

8.

Go

to

Chapter

4,

“Completing

the

parts

replacement,”

on

page

39.

Figure

22.

Removing

the

diskette

drive

or

optional

card

reader

drive

Chapter

3.

Installing

options

and

replacing

hardware

31

Advertising