Avaya 38DHB0002UKDD - Manual (Page 76)

Page 76 - Part 1 IP Connectivity How Do I?
Task Description
Step 1
Configure INDEX environment using the (T)
type interface option (see page 70).
The configuration must ensure the DDI digits
<396010> are routed to the IPNC line card.
Step 2
Test INDeX configuration for both Units.
Use the Monitor application, select Call and enable
Call events. Point the Monitor application to the local
IPNC and dial the ARS routed number configured in
Step 1 from an on-switch extension. The Call event on
the Monitor Application must indicate the call is
presented to the local IPNC.
The resultant tone returned by the on-switch extension
(i.e. engaged or busy) is NOT significant at this stage.
It is only important that the call is presented to the
IPNC.
Step 3
Obtain the configuration file for the IP401 and
the IPNC. Create an Intranet Service type
using the Service parameters set out below.
Services Parameter
IPNC IP401
Name IP401 IPNC
Account Name IPNC IP401
Password password1 password2
Incoming Password password2 password1
For quick set-up, avoiding the use of separate
incoming and outgoing account names, use a
common Service Name and Service Account Name.
For example, on the IPNC set both the Name and
Account Name to ISDN_link and set both the Service
Password and Service Incoming Password to a
unique password that is common to both sites. Then
configure the IP401 using these identical parameters.
(See Service Configuration on page 46)
Step 4
On the IP401 Service form, configure the
Telephone number to access the IPNC on the
Corporate network.
• Telephone number 396010
It is good practice to initially configure dial up
operation in one direction only. If a 9 is used to access
the external line then this must precede the number to
be dialled.
Step 5
In the Extension field of the default RAS (Dial
In) on the IPNC add the number to match the
Incoming call (DDI).
The RAS allows the router to identify which incoming
number are to be associated to data routing. The RAS
Extension field is use for this purpose and by default
the match is made from right to left.
Step 6
For the IP401 and the IPNC apply the
parameters on the PPP tab of Intranet service
type (created previously) as described in the
table below
Parameter
IPNC IP401
Service/PPP
1. Multilink
2. IPHC
Yes Yes
RAS/PPP
1. Multilink
Yes Yes
This configuration is suitable for VoIP with any
compression mode other than G711.
(See The PPP Tab on page 52)
Page 76 - How Do I? INDeX IPNC Cassette Administration Manual
Part 1 IP Connectivity 38DHB0002UKDD – Issue 7 (22/11/02)