Konica Minolta bizhub PRESS C70hc - Manual (Page 44)

IC-601 5-6
5.1 Windows Vista/Server 2008/7 5
% To use the LPR/Port9100 protocol, select [Standard TCP/IP Port].
% To use the SMB connection, select [Local Port].
6
Click [Next].
7
Specify the IP address and port.
% To use the LPR/Port9100 protocol, select [TCP/IP Device], and then enter the IP address.
% To use the SMB connection, enter "\\NetBIOS name\print service name" in the [Port Name] box.
% Enter the same NetBIOS name and print service name specified in [Print Settings] in [SMB Settings].
8
Click [Next].
% If [Additional Port Information Required] or [More Port Information Required] dialog box appears, go
to Step 10.
% If the [Install the printer driver] dialog box appears, go to Step 13.
9
Select [Custom], and then click [Settings...].
10
Change the settings according to the port, and then click [OK].
% For LPR connection, select [LPR], and then enter "Print" in the [Queue Name:] box.
% You must discriminate between upper and lower case letters when entering it.
% For Port9100, select [Raw], and then enter a RAW port number (initial setting: [9100]) in the [Port
Number:] box.
% If both LPR and Port9100 are enabled on this machine, the printer driver is connected to this ma-
chine using LPR.
11
Click [Next].
The [Install the printer driver] page appears.
12
Click [Have Disk...].
13
Click [Browse...].
14
Select a desired printer driver folder in the CD-ROM, and then click [Open].
% Select a folder according to the printer driver, operating system, and language to be used. Available
printer drivers:
PS Plug-in driver, PPD driver , XPS driver
15
Click [OK].